PACKAGE CONENTS
C-10SW & MB-C10
In-Ceiling Subwoofer System
Installation Guide
C-10SW*
Two (2) pairs of steel
mounting rails
The MB-C10 combination mounting & pre-construction bracket and the C-10SW 10" woofer
assembly are packaged and sold separately. These instructions accompany both.
Speaker Mounting Handle
The MB-C10 & C-10SW In-Ceiling Subwoofer system has been designed to
mount directly to 16" OC, 19.2" OC & 24" OC wooden frame construction
members (ceiling joists and trusses).
The integrated system weighs approximately 11 pounds, which is much too
heavy to be suspended overhead in sheetrock especially when you take
into consideration the punishing excursions the 10" long-throw woofer is
capable of.
For the sake of safety, the system is designed such that the entire assembly
is mounted directly to the structure’s framing members. It actually re-
enforces the sheetrock by unitizing it, the assembly and the structure’s
framing together.
Four (4)
Speaker
Mounting
Screws
Grille
Removal
Tool
Primarily designed for “new construction”, in some cases it may also be
retro-fitted into existing construction, which is to say, after the sheetrock is
in place. This may be accomplished when access to the “other side” may
be gained. The structural mounting bracket may be installed from above
the sheetrock.
*Grille also included, but not shown
OEM Systems Co., Inc.
740 Freeport Boulevard, Suite 106, Sparks, NV 89431 (775) 355-0405
|