PAC Work Light C2R VW User Manual

C2R-VW  
Radio Replacement interface for Volkswagen  
Use for Aftermarket Navigation radios that require Vehicle  
Speed Sense, Reverse, Parking Brake and Illumination inputs.  
Class 2  
1 0 0 0 1 1 1 0 1 1 1 1 0 0 1 0 0 1 1 0 1 1 0 0  
J1850  
Class 2  
1 1 1 0 1 0 0 0 0 1 1 0 1 1 0 1 1 1 0 0 1 1 0 0  
* 2002-2005 VW vehicles do not have a reverse or parking brake signal on the CAN-Bus. The Green and Red/White wires do not  
function for these model year vehicles. Parking brake and reverse signal wires can be found with a volt meter in the vehicles factory  
wiring. Vehicle must have a factory installed double din headunit (4” tall).  
16 pin  
Yellow = +12v Constant  
Black = ground  
Gray = Right Front (+)  
Gray/Black = Right Front (-)  
White = Left Front (+)  
White/Black = Left Front (-)  
Violet = Right Rear (+)  
Violet/Black = Right Rear (-)  
Green = Left Rear (+)  
Blue/White = Vehicle Year Select  
Black/White = N/A  
Green = Reverse output (2005.5-2007)  
Orange/White = Parking Light output  
Violet/ White = Vehicle Speed Sense (VSS) output  
Red/White = Parking Brake output (2005.5-2007)  
Green/Black = Left Rear (-)  
6 pin  
Red = +12v Accessory output  
VW Ra  
11 pin  
1 amp  
fuse holder  
To optional SWI-CAN interface for retaining steering wheel audio controls  
Installation:  
1. Connect the aftermarket radio’s front and rear speaker wires to the 16 pin plug.  
3. The 16 pin harness has a yellow and a black wire. Connect the yellow to the radio’s +12v constant wire and the black to the  
radio’s ground wire.  
4. The accessory wire is located on the 6 pin harness - connect this wire to the radio’s accessory wire. The accessory wire  
supplies +12v, 1 amp max, when key is in the accessory or Ignition position. If more current is needed refer to Fig. 1.  
5. 11 pin plug:  
1. Blue/White - For 2002-2005, Connect this wire to the Battery 12v source. For 2005.5-2007, Insulate and DO NOT USE!  
2. Black/White - N/A.  
Fig. 1  
High Current 12v  
(using a SPDT relay)  
(Fused)  
3. Green - Connect this wire to the radio’s Reverse input wire only.  
4. Orange/White - Connect this wire to the radio’s Illumination input wire only.  
85  
87  
86  
12v Acc.  
From  
Interface  
5. Violet/White - Connect this wire to the radio’s VSS input wire only.  
6. Red/White - Connect this wire to the radio’s Parking brake input wire only.  
Note: Do not connect these wires to any other circuit besides the radio’s wire harness.  
Ground  
87a  
30  
Diode 1N4005  
or equivelant  
New High  
Current Output  
6. When all connections are made, connect the 16 pin plug into the vehicle’s 16 pin harness.  
7. Refer to the radio’s manual for testing VSS, Reverse, Parking Brake and Illumination inputs (if used).  
DISCLAIMER: Under no circumstances shall the manufacturer or the distributors of the C2R-VW parts be held liable for consequential damages sus-  
tained in connection with the C2R-VW. The manufacture and it’s distributors will not, nor will they authorize any representative or any other individual to  
assume obligation or liability in relation to the C2R-VW other than its replacement.  
Pacific Accessory Corporation - Santa Ana, CA 92705  
10-07-09  
 

MTX Audio Speaker 512C User Manual
Multiquip Portable Generator DCA 100SSJU User Manual
Navman GPS Receiver Tracker500 500i User Manual
NEC Computer Monitor FP1355 User Manual
Oregon Scientific Portable Radio WR602 User Manual
Oricom Cordless Telephone ECO70 User Manual
Panasonic DVD Player DVD S511 User Manual
Panasonic Electric Shaver ESLA63 User Manual
Panasonic Patio Furniture EP MA73 User Manual
Patton electronic Network Card Asynchronous User Manual